Note: Ensure not to probe on the bends, and end each straight using the red button / H key.
The Output window will then prompt to Measure Straight Segments.Probe a minimum 3 points on start plane of the tube using the green button / G key.The Measurement window will show prompt to Measure Tube - Start plane.Default Bed Radius - enter default bend radius This is normally detailed on the component drawing with the tube / pipe bend data.This will also automatically align the Measured and nominal tubes, providing comparison data. Nominal - select Nominal Tube if available.Low Point - lowest plane reading (minimizes tube length).High Point - highest plane reading (maximizes tube length).Plane calculation methods: There are 3 methods to fine-tune tube length:.
3D Hand Held Scanner - Freestyle3D Objectsįrom the Measurement ribbon select Tube by Cylinders (also via Home - Measurement gallery).
